Recalculating existing units

With the GPC you can not only design new units, but you can also recalculate existing units. For this purpose, open the input mask Input data and here the tab unit selection. Check the box Calculate single unit. Then select in the tab Thermodynamics the calculation mode Calculate capacity and enter your data. If deviations to an existing data sheet occur, please verify the following input parameters for the GPC’s thermodynamic calculation: rel. humidity, geodetic height, inlet temperature, superheating and subcooling temperature, frost thickness, etc. Also the selected accessories, such as epoxy fins, air socks or stainless steel tubes have an influence on the unit’s capacity!

Share this page

If you can't find the answer you're looking for, e-mail: software@guentner.de or contact your consultant at Güntner.

We continuously work towards improving the GPC program and our support so that you are always informed about the latest features and extensive program functionalities.

Your Güntner Software Team